Leprecon LPC V2 User's Manual Manual do Utilizador descarregar pdf (Página 56)

LPC 48 / 96 Users Manual

Page 56

7 Chase

LPC uses Chase patterns to run sequences. Chases can be linked to Cues or

Submasters, or selected and controlled from a front panel fader.

The first four chases are permanent system chases, and cannot be altered.

There are a total of sixteen programmable chase patterns available.

7.1 Chase properties

Each LPC chase has the following properties:

 Pattern - specified which chase is being recorded.

 Step - shows the last step saved

 Rate - the speed of the chase, shown in Beats Per Minute (BPM)

 Loop Count – Setting a value for Loop Count will stop the chase after a

specific number of cycles.

 Blend - Chases can be set to snap from step to step, or fade from one step to

the next. Setting blend to zero sets the chase to snap, and a blend value of

100% will produce a fluid chase that is constantly fading from one step to the

next.

 Title – A name given to a specific Chase pattern.

7.2 Recording Chases

Select Record Chase to see the options for building a new chase. Data relating

to the specific chase is shown at the top of the screen, and channel data is

shown below, (See Figure 35).

Patterns 1 - 4 are permanent and the steps cannot be changed.

1. In Record mode select the Pattern number from the menu.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 121 122

Sem comentários

Leprecon LPC V2 User's Manual Manual do Utilizador Página 56